A carrier that fits poorly will not carry weight well, no matter how good the shell is. Most fit problems come from three things: the plate pockets are the wrong size, the shoulder straps are set too long, or the cummerbund is not tensioned. All three are fixable before bulk if the measurement set is right.

1. Start with the plate, not the body

The carrier is built around the plate. Measure your plate length and width, including the curve, and confirm the pocket dimensions with the factory. A pocket that is 10 mm too small will not accept the plate; one that is 20 mm too large lets the plate shift. Front and back plates can differ — specify both.

2. Shoulder strap adjustment

Set the shoulder straps so the top of the front plate sits roughly at the collarbone and the top of the back plate sits at the shoulder blade line. If the front plate rides too low, it restricts movement and leaves the upper chest exposed; too high and it presses on the throat. The adjustment range should be long enough to wear the carrier over a jacket.

3. Cummerbund tension

The cummerbund should wrap the torso firmly but not restrict breathing. Too loose and the carrier rotates when you move; too tight and it pulls the plate pockets out of shape. Elastic cummerbunds tolerate a wider range than padded ones, which is why lightweight carriers use them. Check the tension with the carrier loaded, not empty.

4. Ride height and load placement

With the carrier on, the front plate should cover the centre of the chest and the side panels should sit at the natural waist. Pouches add weight forward, so test the ride height with the pouches attached. Heavier pouches should sit close to the body and slightly low; a radio or admin pouch can sit higher.

5. Size range for a production run

Most carriers are sold in S/M and L/XL, with the cummerbund doing most of the adjustment. If your market includes a broad size range, specify the adjustment range rather than adding sizes: an extended shoulder strap and a longer cummerbund often cover two nominal sizes. For an XL cut, confirm the plate pocket size does not change — the adjustment should come from the harness, not the pocket.

What to send the factory

  • Plate length and width for front and back.
  • Body-size range you need to cover.
  • Pouch list and approximate weights.
  • Whether the carrier is worn under or over a jacket.

We build carriers to your plate dimensions and send a measured sample for fit testing before bulk. Plates and ballistic inserts are not supplied; the carrier is a load-bearing garment, not armour.