MOLLE is the attachment system; PALS is the grid it attaches to. The distinction matters because most quality problems show up in the grid, not in the pouch. If the rows are uneven, the backing is too soft or the bar-tacks are missing, pouches will sag, shift or tear out under load.

The PALS grid

PALS stands for Pouch Attachment Ladder System. Webbing is sewn in horizontal rows at 25 mm intervals, with vertical stitches every 38 mm. The resulting ladder accepts the straps of a MOLLE pouch, which weave through the rows and snap back on themselves. The 25/38 mm spacing is what makes pouches from different makers interchangeable — if it is off, the system stops being modular.

Why bar-tacks matter

Every row end and every stress point should have a bar-tack: a dense, short stitch that reinforces the webbing where it is most likely to pull out. On a cheap pack, the MOLLE rows are sewn with a single stitch line and no bar-tack. Under a loaded pouch, the row end starts to fray and the pouch droops. Ask for a close-up of the row ends on a production unit.

Webbing MOLLE vs laser-cut MOLLE

Traditional MOLLE is sewn webbing. Laser-cut MOLLE is a panel of laminated fabric with slots cut by a laser, which reduces weight and eliminates the webbing rows. Laser-cut panels look cleaner and save weight, but the laminate must be stiff enough to hold a loaded pouch without deforming, and the cut edges need to be sealed against fraying.

  • Webbing MOLLE: stronger, repairable, heavier, more traditional look.
  • Laser-cut MOLLE: lighter, cleaner, faster to produce; requires a quality laminate.

Planning the layout

Start from the load, not the panel. Lay out the pouches you actually carry, measure their strap spacing and decide the order of use: items you reach for most go at chest or belt height, heavier items sit close to the body, and anything that could snag goes inside a pocket. A common mistake is filling every row because it is there — a pack with four well-placed pouches carries better than one with ten badly placed ones.

What to check on a sample

  • Row spacing: measure three rows across the panel, not just one.
  • Bar-tacks: every row end and every strap anchor.
  • Backing stiffness: load a pouch and check for sag.
  • Edge finish: bound or sealed, no loose threads.
  • Pouch fit: attach a real pouch, not a factory dummy.

We cut and sew both webbing and laser-cut MOLLE in Guangzhou, and we will send a photo set of the row ends and bar-tacks with every sample so you can check the grid before bulk. If you have a pouch platform already, send one pouch and we will build the panel around it.